GTEM v1 Energy Monitoring board main features (Provisional):
- Espressif ESP32 WROOM 32
- 2.4GHz Wi-Fi and Bluetooth LE MCU module, with dual core CPU
- ATM90E26 (Energy Monitor)
- Metering features fully in compliance with the requirements of IEC62052-11, IEC62053-21 and IEC62053-23
- Active Energy LED / Input to ESP32
- Reactive Energy LED / Input to ESP32
- AT24C64 EEPROM
- For storing parameters, calibration data, Logs etc.
- OLED I2C Connector
- Current Clamp Input
- AC Low Voltage Input
- Power safely derived from a SELV / Wall AC/AC Power Supply
- On-board 3V3 DC Power Supply
- USB UART
- Micro USB. Uses the popular CH340 for ease of developing code, flashing and debugging
- Arduino D1 Flashing and Programming Compatibility
- No drivers normally needed
- OPTO Input
- Meter Pulse Opto Reader
- On-board Temperature Sensor
- NTC (range -40ºC to +125ºC)
- Reset Button
- User GPIO
- User Programmable Button
- RGB LED (ESP software code / firmware controlled)
- DC Power LED (red)
- PCB designed to fit into an BMC enclosure (available separately)
- Also allows for the display to be included, or not (available separately)
- PCB Size 65mm x 53m